What are the installation methods for fast rolling doors? With the rapid improvement and development of China's industrial economy, the demand for large fast rolling shutter doors is constantly increasing, and they are widely used in various industrial factories, logistics channels, workshops, warehouses, computer rooms, garages, and other places. With the improvement of the industrial door series products, the reasonable requirements for the appearance, wind power, driving and control systems, manufacturing process, and service life of the door body by the use unit are also becoming higher and higher.
1. Before installing the fast rolling door shaft, install the hanging plate in the direction of the shaft, and then install 4-6 curtains onto the hanging plate and roll them onto the shaft. The Sichuan power line has been fixed.
2. When lifting the large axis of the fast rolling door, be sure to pay attention to safety. Special personnel commands, ladders, scaffolding, and chain hoists must be checked. When installing the quick shutter door, first insert the bearing and the optical axis of the seat into the end hole of the roller shaft, and then tighten the bearing fixing bolts after aligning them.
After the scroll is in good condition, you can move the scroll to the left and right to adjust its position. At the same time, check the height of the scroll using a horizontal tube and a horizontal tube. After adjustment, the optical axis and scroll are completely welded and fixed, and the optical axis and bearings are fixed with cap screws.
When lifting the scroll, please be particularly careful not to damage the curtains wrapped around the scroll. When bundling with steel wire ropes, a backing plate is required.