Components involved in the installation of quick doors

Oct 04, 2023 Leave a message

Usually, quick doors are installed to deal with fixed fixed fixed surfaces on both sides of the ventilation hole. However, in areas with limited indoor space, although the suspended plate guide plate can be installed inside the ventilation hole, this can endanger the aspect ratio of the opening.

The door curtain is mostly composed of single-sided 75mm deep cold rolled steel plate, which is installed horizontally. All of them are self-locking and interlocked by odd parts, so that the finished curtain tightly revolves around the steel cylinder fixed on the top of the clear opening and "turns". The thickness (thickness) of each aluminum plate is selected to integrate the wide day wind load of the door.

Polyester or steel fixed clamp plates (end locks) are fixed on the reserved aluminum plate to prevent individual aluminum plates from slipping over. The stiffness of the bottom end slide shows compressive strength and is generated by a portion of the steel chain 'T', the viewing angle, or a portion of the shell (if necessary) to maintain a small lateral offset. The curtain fabric operates on a vertical slide rail made of thick gauge hot-dip galvanized "U" steel. Low position steel roller bucket, which can accommodate rolled curtain fabric when the door is in the open position.

The slide rail is fixed by standard components on ultra heavy steel corner pieces, and is installed on formed openings that can be made of steel, bricks, concrete, or even wood.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry