Solution To The Derailment Fault Of Industrial Fast Doors

Oct 08, 2023 Leave a message

Due to the fact that the curtain of industrial fast doors is made of PVC soft material, improper use may cause the curtain to derail. There are two reasons for the derailment of industrial express doors. Firstly, industrial express doors are installed at the entrance of the passage. If a forklift accidentally hits the door curtain, this situation will definitely cause the door curtain to derail. Secondly, the wind resistance level of industrial express doors is around 6. If the hole size ratio is large and installed outdoors with wind pressure, it may cause the door curtain to be blown off the track. So when there is a phenomenon of derailment, are there any solutions?

The solution to the derailment fault of the industrial fast door is as follows:

1. Confirm that the guide strip and guide groove are in good condition, otherwise damaged parts need to be replaced. Confirm that the door curtain has been reset during operation (the guide strip has entered the guide groove).

2. Confirm that the position of the industrial fast door after it is fully opened should be higher than the reset point, otherwise it is necessary to readjust the limit of the door and confirm that the sealing gasket inside the track is well sealed with the track.

3. Confirm that the 150mm sealing gasket inside the track is in good condition, and that the 150mm sealing gasket inside the track is not worn. If there is any damage, it needs to be replaced.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry